A Weather Station

We have an underground storage tank, which was used for irrigation when the surrounding area was an orchard before the house was built. It’s not as deep as it used to be, but still holds around 2000 gallons of water when full. It’s filled from half of our house roof, and all of the garage roof. There is a submersible pump in it which we use to water the garden.

Measuring the water depth has always been a challenge, and you can just see a white measuring stick – but all the markings on this faded over time!

Last year, I purchased an ultrasonic depth sensor which worked fairly well but wasn’t robust enough to survive outdoors.

So this year, I bought an industrial pressure sensor, which now sits at the bottom of the tank:

I found an small microcontroller board that has a suitable input for this – this board also has integrated WiFi so it can send the measurements back to the house.

This sends the data to some logging software running on our Raspberry Pi based server.

This works just fine, but being a pressure sensor, the recorded level varies slightly with atmospheric pressure changes. So a bit more digging found this little board, which measures barometric pressure and temperature:

I found a design for a small “Stevenson Screen” to hold this board, which I printed on my 3D printer:

This also connects to the WiFi board.

You can see the results from these sensors by viewing http://home.wsn.uk:5555 username ‘view’, password ‘view’. Click on the icons to see the graphs showing these inputs change.

The next task is to adjust the Water Level reading with atmospheric pressure!

Some baby plants arrive

While I had a subscription to Gardener’s World Magazine, I sent off for some mini plug plants, which only cost the postage.  They arrived in what looked like an impossibly small package, but inside were 30 tiny plants in 30 tiny pots.

They were quite damp and seemed to be happy, but I thought it best to up-pot them pretty quickly.

It turned out that some of the tiny pots actually held more than one seedling, but I put each pot’s worth into one of my home made paper pots.

Now I am left with 30 tiny plant pots.  Can I find another use for them, so they are not single-use plastic?

Back to Aston Marina

Another persistently damp day, with gusts of wind at the most inconvenient times…

But we got the boat back into its mooring eventually, then spent a while pumping it out and refuelling with water and diesel.

7 miles and 10 locks today.

Trentham

After lunch, we had a quick wander up to the tunnel mouth:

Then turned around and headed south through Stoke-on-Trent. Weather was rather showery all afternoon, and getting quite windy towards the end.

But we did have a few locks to give us some exercise!

15 miles and 8 locks today.

Milton

We retraced back along the Leek Branch to rejoin the main canal at Hazlehurst.

After lunch we headed down to Milton.

Rocco managed to end up in the canal (not sure if he just slipped), thankfully the bank wasn’t that steep and I was able to drag him out with his harness.

10 miles, 7 locks, 2 tunnels and 2 lift bridges today.

Leek

We moved on up the Leek Branch of the Caldon Canal, and are now moored just outside Leek.

Some nice bluebell woods by the canal:

There was a short tunnel on route:

And this is the end of the canal:

Hazlehurst Locks

Last night, we moored right next to some interesting woodland with a signpost to a circular walk. So it was the obvious choice for Rocco’s morning walk.

Lots of bluebells, wild garlic and sticks!

We then carried on to the end of the Caldon Canal – unfortunately the boat is too large to fit through a short tunnel near the end.

Then it was heading back up the canal, stopping in Cheddleton just as the heavens opened.

Duncan and I walked into the village to top up the beer supply, then we moved on to Hazlehurst Locks, where the Leek Branch diverges.

8.5 miles and 10 locks today.